Supported loggers › spaceLYnk
spaceLYnk
spaceLYnk has a built-in KNX bus connection, so it works as the KNXSENSE logger without a separate KNX/IP gateway.

How the logger works.
The KNXSENSE logger is installed on the device as separate software. It has no effect on anything else the device does. Logic, visualisation, interfaces and scripts keep running as normal.
The logger only reads bus traffic and never writes to the bus. The connection is established outbound from the site, so no open ports and no static IP address are needed. The logger also works behind a shared carrier IP address.
Logging requires spaceLYnk to be powered on continuously and the site to have an internet connection.
- Specifications
- Manufacturer
- Schneider Electric
- Remote ETS access
- Via KNXSENSE
- Manufacturer’s product page
- se.com →
KNXSENSE-compatible models
- LSS100200
How telegrams reach the recording.
spaceLYnk is connected directly to the KNX bus, so it sees the telegram traffic on its own line and everything the line couplers route onto that line from the other lines.
KNXSENSE compares the addresses it sees against your ETS project and tells you straight away which lines and devices are in the recording and which are missing.
KNX bus monitoring in your browser.
Jokainen sanoma, jonka spaceLYnk näkee väylällä, tallentuu ympäri vuorokauden millisekunnin tarkkuudella tietoturvallisille palvelimillemme , myös silloin, kun et ole paikalla.
Telegram-level history reaches 400 days back on a rolling window. You can browse it in your browser, on any device, without the ETS software.
ETS tunnelling through KNXSENSE.
You open the connection from the interface, and from there you program the site in ETS as if you were on site.
Logging reserves no ETS tunnel slots at all. All tunnel slots stay available for ETS.
Remote access is included in the KNXSENSE monthly fee. No separate portal, licence or port forwarding is needed.
Setting up spaceLYnk as a KNX logger.
KNXSENSE’s setup assistant walks you through the right settings step by step.
The whole setup takes only a few minutes.
- Import your ETS projectNames and structure from the project into KNXSENSE
- Install the loggerGuided install on the device
- Logging is runningThe first telegram from the site’s bus confirms the connection
Setup is a one-off job. When updates to the logger are released, they are installed on the device automatically. Updating requires no action from you and no visit to the site.
Other supported loggers.
These devices are compatible with KNXSENSE too. Compare all →