Supported loggers › 1Home Server KNX Pro
1Home Server KNX Pro
The 1Home Server KNX Pro has a built-in KNX bus connection, so it works as the KNXSENSE logger without a separate KNX/IP gateway.

How the logger works.
The KNXSENSE logger is installed on the device as separate software. It has no effect on anything else the device does. Logic, visualisation, interfaces and scripts keep running as normal.
The logger only reads bus traffic and never writes to the bus. The connection is established outbound from the site, so no open ports and no static IP address are needed. The logger also works behind a shared carrier IP address.
Logging requires the 1Home Server to be powered on continuously and the site to have an internet connection.
- Specifications
- Manufacturer
- 1Home
- Remote ETS access
- Via the device’s own channel
- Manufacturer’s product page
- 1home.io →
KNXSENSE-compatible models
- Server KNX Pro
How telegrams reach the recording.
The 1Home Server is connected directly to the KNX bus, so it sees the telegram traffic on its own line and everything the line couplers route onto that line.
KNXSENSE compares the addresses it sees against your ETS project and tells you straight away which lines and devices are in the recording and which are missing.
KNX bus monitoring in your browser.
Jokainen sanoma, jonka 1Home Server näkee väylällä, tallentuu ympäri vuorokauden millisekunnin tarkkuudella tietoturvallisille palvelimillemme , myös silloin, kun et ole paikalla.
Telegram-level history reaches 400 days back on a rolling window. You can browse it in your browser, on any device, without the ETS software.
ETS tunnelling over the device’s own route.
The device has its own remote access, included at no extra cost. ETS sees it as an ordinary KNX/IP gateway, so you program the site as if you were there, with no ports opened on site. The connection is opened from the device’s own interface.
Logging reserves no ETS tunnel slots at all. The device’s own KNX/IP gateway offers four tunnel slots for ETS.
KNXSENSE does not provide its own ETS tunnelling for this device. Remote access runs over the device’s own route alongside logging.
Setting up the 1Home Server as a KNX logger.
KNXSENSE’s setup assistant walks you through the right settings step by step.
The whole setup takes only a few minutes.
- Import your ETS projectNames and structure from the project into KNXSENSE
- Install the loggerGuided install on the device
- Logging is runningThe first telegram from the site’s bus confirms the connection
Updates are made in the device’s user interface. When an update is released for the logger, you apply it from the setup wizard. It is the same few-minute task as the installation.
Other supported loggers.
These devices are compatible with KNXSENSE too. Compare all →